In the Calculate node, would it be possible to have a clamp to one bound only?

Let’s say I have data that is “naturally” bounded to 0 for the low limit, I don’t really need the formula to check if that data is going lower than 0. I only need the formula to check if the data is going over the high limit and clamp it to that high limit.

I’m asking this because I imagine that checking only one limit would save a few CPU cycles.

@Kewl, thanks for pointing that out. I’d like to clarify the documentation. It sounds like you understood that you could use clamp (whose documentation explains x, min, max) but not min and max?