delay

Edwin_van_Steenbergen · May 12, 2021, 8:56am

I have several texts that need to be spoken and projected. But I need a pause between the texts. How do i make this possible.

texts projected and spoken.vuo (6.93 KB)

Bodysoulspirit · May 12, 2021, 5:20pm

Joined is one method if I’m right.

It’s set to 3 seconds interval between the texts.
The numbers on the magenta nodes need to be the same (set to 3 seconds for 3 ports).

Hope this helps

Texts projected and spoken 1.1.vuo (8.99 KB)

cremaschi · May 12, 2021, 6:30pm

This way works.

regards
mic

cremaschi.wait_.vuo (1.97 KB)

Edwin_van_Steenbergen · May 13, 2021, 10:55am

Thanks very much, the both of you. It really works.

jmcc · May 13, 2021, 5:30pm

@Bodysoulspirit’s solution could be simplified a little by replacing Smooth with Duration with Measure Time, as the Rotate on Cue example composition demonstrates.

Bodysoulspirit · May 13, 2021, 8:15pm

Bodysoulspirit’s solution could be simplified a little by replacing Smooth with Duration with Measure Time, as the Rotate on Cue example composition demonstrates.

True ! Thanks Jean Marie.

Texts projected and spoken 1.2.vuo (8.32 KB)

Edwin_van_Steenbergen · May 14, 2021, 7:58am

Thanks so far. It really helped me out. Now I have another question, but I’ll start a new discussion for that.

jersmi · May 27, 2021, 7:14pm

Appreciate the solutions for delays. Still wishing for more of a buffer type delay – input any data type, output data delayed by n seconds.

jmcc · May 28, 2021, 5:40pm

Still wishing for more of a buffer type delay – input any data type, output data delayed by n seconds.

Perhaps create a new Feature Request?

jersmi · May 28, 2021, 6:17pm

Done! Wasn’t sure if there was a solution with available nodes, you cleared that up. :-)